The Flower
Trimmer is Fast and Effective!
It will
astonish you!
Used on small onions,
radishes and various herbs which require protruding leaves
and roots to be removed and preparation of essential oil,
and for the mixture of flower petals for aromatherapy.
Manufactured
in Holland since 2002 imported to Canada since January 2006
the FLOWER Trimmer is the most appreciated at this day by
the users and owners of location centers. Small, light and
very powerful, this machine gives very convincing
results.
FLOWER Trimmer is completely safe. No safety measure
is necessary, the cutting wire can only turn if the lid is
closed.
The FLOWER Trimmer is almost soundless, when the wire spins
free from the grill. It can be used at night, without any
problem. We haven’t yet seen any plants that are not
suitable. Both indoor and outdoor plants can be used.
Simply separate the matter from the stem of the plant and
place it on the grid without any special
disposition.
You don't have to trim buds before
or after trimming with the FLOWER Trimmer, just remove the
buds from the plants. The buds are trimmed all around, no
hidden stalks or missed leaves . Both large and small buds
can be trimmed succesfully by the FLOWER Trimmer. The
spiral gap of the grill is only 6 mm, so the buds that are
smaller than this may pass through the grill, buth not much
remains of them, when they are dried. There is also very
little loss of resin glands, just a few grams per kilogram.
It is also advisable to devide the largest buds from
smaller buds, as they may take some extra time.
The buds are handled gently by the Trimmer. They are
rolling at less then half the speed at which the crank is
turned. Because they are constantly held against the grill
while they are rolling, they are finished after just 12 to
15 rounds. The leaves can be recovered for future
transformations, if needed.
The
gears of the FLOWER Trimmer can not be broken, if something
get stuck, The gearbox of the FLOWER Trimmer is equipped
with a torque limiting device, that protects the gears
against excessive forces.
It
should be noted that the FLOWER Trimmer is only effective
with fresh plants. You can keep the plants and its
flowers by placing the stems of the plant into water.
Simple and easy of maintenance, chrome stainless steel
parts, simply use no stick cooking spay and let work from
30 to 45 minutes then wipe with a soaking paper.
The
FLOWER Trimmer is an ecological trimmer, activated by human
energy, no chemical finish-adhesive, the rubber used does
not have any compound containing Chlore.
The FLOWER Trimmer is 43cm/ 17 inch in diameter, 35cm/14
inch high and weighs 4.3 kilos/ 10 pounds.